How to Resolve Continuous Empty Grounds Error on Gaggia Velasca

Continuous Empty Grounds Error

If you are not able to clear the Empty Grounds Drawer error message on your Gaggia Velasca, refer to the instructions below on how to clear the error and resume brewing espresso.

If the “empty grounds drawer” or “empty drip tray” message will not clear, then one of the drip tray sensors may be malfunctioning. This can happen if the spout on the front of the machine is improperly positioned, causing brewed coffee to spray inside the door where several electronic sensors are located. If these sensors get wet, they can temporarily short out, or they may be permanently damaged and require repair. Follow the steps below to resolve the issue:

  1. Make sure that you are emptying the grounds drawer/drip tray while the machine is turned on and out of standby.
    • Once emptied, wait 15 seconds or so before reinserting. The machine will not reset the counters for these sensors unless it is powered on.
  1. Remove the spout completely from the machine.
    • It will pull straight forward for removal.
  1. Unplug the machine.
  2. Open the front door and prop it open.
    • Leave the machine like this for at least 48 hours. If the sensor is wet but still operational, it needs time to dry out before the machine will function again. A small fan blowing on the back of the door will assist in drying the unit out.
  1. Reassemble the machine.
    • Ensure that the brewing spout is perfectly aligned. Alternatively, it can be left off the machine and coffee will come out in a single stream instead.
  1. If the machine is still displaying the error message try emptying the grounds drawer and drip tray while the machine is on.
    • If the message still does not clear after doing this then the drip tray sensor is damaged and the machine will require a repair.
Was this article helpful?
0 out of 0 found this helpful