Profitec Pro 800: Portafilter Does Not Fit

Troubleshoot portafilter handle not fitting on Profitec Pro 800.

Portafilter Handle Not Fitting On Machine

If you’re having trouble locking in the portafilter on your Profitec Pro 800, there are a few things it might be. Take a look at the list below to diagnose and resolve the issue.

  1. On all new machines, the portafilter may or may not fit perpendicular to the machine. This is perfectly normal. This is because the grouphead gasket requires time to wear in before this can happen. As long as you can get the portafilter hand tight onto the machine and brew without leaking, then the machine is operating properly.
  2. Too much coffee may be dosed into the portafilter. If there is too much coffee in the portafilter, it can press into the shower screen and prevent the portafilter tightening all the way. Reduce the amount of coffee in the portafilter and try again. If you see an indentation from the shower screen in the grounds, then you’ve added too much.
  3. Check the filter baskets for dings, dents, or any sort of warping. A filter basket that is malformed can prevent the filter basket from sealing up against the group gasket.
  4. The group gasket has slipped out of place or needs replacing. Please refer to this article for instructions on how to test the gasket or replace it.
Was this article helpful?
0 out of 0 found this helpful