How To Resolve Getting No Flow from Steam Wand on the Bezzera BZ10

No Steam From Wand

  1. Check the brew function on the machine and see if water is able to flow through the machine for this function.
      • If the brew water is not flowing either refer to this machine's "No Water Flow" article.
      • If the brew water flows but is not hot refer to the "On But Not Heating" section of this machine's "Steam Not Heating" article.
  2. Check the hot water function of the machine. If you are able to draw hot water then the steam boiler must be pressurizing and heating, because hot water is expelled from the machine by steam pressure. The steam pressure gauge should also read 1-1.2 Bar to indicate the boiler is pressurized.
      • Remove the tip from the steam wand and test the flow. If flow is restored then the tip needs to be cleaned and reattached.
      • If the flow is still blocked then there may be a blockage in the steam wand itself. Clean the wand by using a pipe brush that has synthetic or plastic bristles; metal bristles can damage the wand. Then soak the wand in a solution of hot water and backflushing powder for ten minutes. Test flow again.
      • If there still isn't flow then there may be a blockage farther back in the steam circuit. The machine may need to be professionally cleaned to remove the blockage.
Was this article helpful?
0 out of 1 found this helpful