Below you will find step by step instructions with photos on how to remove the housing from your Profitec Move.
Tools Required:
- 2.5mm Allen Wrench
- 3mm Allen Wrench
Step One
Begin by removing the four 2.5mm Allen screws and lifting up the top panel of the machine
Step Two
Place the machine gently on its back, on a soft cloth or towel. Remove the four 3mm Allen screws from the bottom of the housing.
Step Three
Remove the two 3mm Allen screws from the lip on the back portion of the inner housing opposite the water tank guide rail.
Step Four
Remove the two 3mm Allen screws on either side of the front portion of the inner housing.
Step Five
Locate the sliders on either side of the top front portion of the housing. Push down on the housing so the larger portion of the slot cut in the housing lines up with the slider, then pull both sides of the housing outwards off the sliders. You can now gently pull the housing back off the machine.
Reinstallation
Reinstalling is as easy as following these steps backwards. Note that when you start by the sliders you will need to hold the housing in place until you get a couple of the screws reinstalled. It is often easier with a second set of hands to assist with this portion.
Additional Assistance
If you require any additional help, please reach out to us via Phone or Chat!